To reset the lamp timer
- Press the power button on the ECP or remote twice to put the projector back into Standby mode. The power button light on the ECP turns solid amber when the projector is in Standby.
- Press and hold the up button on the remote control for approximately 10 seconds. When the projector beeps, press and hold the down button on the remote control for approximately 10 seconds. The lamp timer clears after another beep.
- Press the power button on the ECP or remote to start up the system. The power button light on the ECP turns solid green when the system starts.
- To confirm that the lamp timer has been reset, press the MENU button on the remote control. Scroll to the Status Display menu heading, and then confirm that 0 h appears in the Lamp timer field. Your lamp reset count has increased by one.
- Wait five minutes for the projector lamp to warm up.
- After confirming that the lamp timer has been reset, put the system in Standby mode by pressing the power button twice on the ECP or remote. The power button light on the ECP turns solid amber when the system is in Standby.
- Wait for the system to enter Standby mode, turn off the projector’s master power switch to shut off the system, and then turn on the projector’s master power switch.
- When you are ready to use the system, press the power button on the ECP to start up the system.